Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
hi i bought proxmark3.
leds blinks and than off. i think it s fine.
but i cant use prox gui;
i read manual, there s no explanation about first run.
firmware version 20090905.
C:\Users\dr\Downloads\pm3-20090905-r216\pm3-20090905-r216\winsrc>prox.e
xe gui
...no device connected, polling for it now
iam using windows7 x86. i didnt install any driver. i didnt compile anything. i just pluged the usb cable and i tried to run prox gui
Client
The client application is written by Jonathan Westhues and connects to the Proxmark via the standard HID protocol. The operating system on the ARM does not represent a proper real-time operating system in the sense that it still polls for things like USB packets. This way it is not possible to stream the retrieved samples on real-time to the PC. So when the ARM retrieves a command from the client it runs this command and stores any useful messages in its memory buffer. After the command finishes the client should send a new command to capture the data from the ARM buffer.
any feedback makes me happy,
thanks a lot
Last edited by darkrevenger (2011-02-08 13:02:58)
Offline
Pages: 1