Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
#1 2021-05-21 19:00:59
- mochenmat
- Contributor
- Registered: 2021-05-11
- Posts: 6
Standalone mode pm3 easy
Is it possible to use the pm3 easy by itself with no computer client? Like copy a key then use pm3 as a key?
Offline
#2 2021-05-26 11:42:12
- gerza
- Contributor
- Registered: 2018-05-05
- Posts: 14
Re: Standalone mode pm3 easy
Yes. you must compile firmware with the mode of your choice in the Makefile.platform file. (only one each)
https://github.com/RfidResearchGroup/pr … alone-mode
if you have the limited 256k version this configuration works fine. you can change the line STANDALONE=HF_MATTYRUN with the mode you prefer to use.
-----Makefile.platform---------
PLATFORM=PM3GENERIC
PLATFORM_SIZE=256
STANDALONE=HF_MATTYRUN
SKIP_FELICA=1
SKIP_ICLASS=1
SKIP_LEGICRF=1
-----------------------------------
some standalone sample:
https://www.youtube.com/watch?v=CjMIabB7lrk
https://www.youtube.com/watch?v=bGwepPhrE6s
https://www.youtube.com/watch?v=OJWUgq23Bps
Offline
#3 2021-06-19 17:29:53
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,538
- Website
Re: Standalone mode pm3 easy
A very wide question, but you might want to read up on Standalone modes.
There is a note about it on RRG/Iceman repo.
Offline
Pages: 1