Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
I have a question while installing proxmark3 rdv2.
When I tried to run after checking the message that the installation was complete while flashing the firmware, the connection was not made and I tried to flash the firmware again.
However, the UART error while setting com state message appears and the time seconds continue to appear.
ex) 60[!] UART error while setting com state
I want to know how to solve it.
The environment used is window 10, port num 4.
The flash file port num is set to bar port 4.
Offline