Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Hey, guys
i've built a proxmark the problem lies is this ive got bleeding edge computer so therefore i do not have a Parrell port on my computer (LPT) for the jtag.. does anyone know of any USB Soloutions to program the proxmark?? such as a USBJTAG??
Offline
How are the SAM7's mentioned in the Document ...
5 USB-Adapter
The USB-Adapter is based on a Olimex SAM7-H64 or SAM7-H256 development board (currently
available for $34.95, check http://www.olimex.com/ ). It is accessed using the libusb library. A
VID/PID combination of 0x1234/0x3333 is chosen.
The armpgm and armserver can both be running and use the USB-Adapter as target interface. However
they will not be able to access the USB-Adapter simultaneously. If you have just finished a debugging
session using armserver, gdb must disconnect from the target before armpgm can be used to reprogram
target flash memory. To disconnect using Insight use meny entry Run->Disconnect, with Eclipse use
meny entry Run->Terminate. In gdb a kill command will disconnect.
thats the document inside the archive
ArmPgm-win32
that someone suggested to me.. when i initialy asked how to build the wiggler...
Offline
Pages: 1