Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2015-03-20 14:23:56
- beben
- Contributor
- Registered: 2015-03-05
- Posts: 32
Command buffer overflow with hf tune
Hi everyone,
I was playing around with hf tune, trying a bunch of RFID cards to sse which were HF, when I encountered some kind of bug.
I usually just run hf tune and check for a drop in voltage when the card is close to my antenna. Today, however, after a little while (around a minute, maybe less) the client started displaying:
WARNING: Command buffer about to overwrite command! This needs to be fixed!
instead of the usual "#db# XXXXXmV". Just thought I'd let you know, since I'm in no way proficient enough to fix this myself (yet).
I'm running the latest linux client (git pull today on master) with firmware 2.0.0-rc2.
Thanks as usual!
TL;DR: Ran "hf tune" for around a minute, got "WARNING: Command buffer about to overwrite command! This needs to be fixed!" 
Offline
#2 2015-03-20 14:46:30
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,537
- Website
Re: Command buffer overflow with hf tune
I suggest you open an issue on GitHub, to get the correct attention.
Offline
#3 2015-03-20 15:45:25
- beben
- Contributor
- Registered: 2015-03-05
- Posts: 32
Re: Command buffer overflow with hf tune
All right, I'll do it immediately!
Offline