Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Hello all,
For a while I have an elechouse proxmark3 easy (as seen here: https://i.pinimg.com/736x/10/51/96/10519679d931a734e8724683fc383e0a.jpg ) - at first it worked great reading & writing rfid fobs/keys on OSX. However, after a few weeks of not using the unit, when plugged in to the same OSX laptop, it is not being recognized with the usual "ls /dev/cu*"
When plugged in to PC, the light sequence is as follows:
1) All lights blink (A, B, C, D) & power LED is white
2) D light blinks again. color blue
3) Only power LED remains white, all others are off.
By pressing the power button it appears to be working in stand-alone mode, if connected while holding the power button, the light sequence is as follows:
1) Power LED = white
2) All lights blink (ABCD), but only (A = green, C = red) remain on
Under this mode it also is not detected with "ls /dev/cu*"
Has anyone experienced something similiar? Any help or suggestions is highly appreciated, thanks!
Offline
Hello there,
I have exactly the same problem after not using my proxmark for a month.
Cannot manage to make it work again.
If anyone got ideas I am up for it
( I tried on 4 different computers, with different cables )
Offline