Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2018-12-02 20:33:55
- chimera
- Contributor
- Registered: 2018-10-26
- Posts: 12
Hotel card dumped - How to read data blocks
Hello,
Actually I am playing with a Mifare classic hotel card. At this point I was able to fully dump the card, thanks to hardnested command set.
For sector 0 a 1st key was used, remaining sectors do have a 2nd key in use.
Actually I am having to problem to understand the data blocks (no value blocks present), conversation from HEX numbers to ASCII or DEC just shows junk....
What is the correct approach to interpret data blocks? How can I find for example room number, Name .....
Thanks for guiding me in the right direction 
Chimera
Last edited by chimera (2018-12-02 20:39:05)
Offline
#2 2018-12-03 20:14:21
- chimera
- Contributor
- Registered: 2018-10-26
- Posts: 12
Re: Hotel card dumped - How to read data blocks
Somebody can provide a hint how to proceed?
Many thanks in advance!
Chimera
Offline
#3 2018-12-03 22:35:14
- szymonunion
- Contributor
- Registered: 2009-07-05
- Posts: 46
Re: Hotel card dumped - How to read data blocks
Hi,
maybe only UID is important for door lock ?
Regards,
Offline
#4 2018-12-04 16:10:41
- Bergera
- Contributor
- Registered: 2018-11-07
- Posts: 7
Re: Hotel card dumped - How to read data blocks
I've run into a couple different things here.
I've seen some that use Mifare Application Directory but most others don't, may be check and see if yours uses MAD?
I haven't had any that specifically are tied to the UID yet.
I have yet to figure out how anything is formatted yet.
Offline