Proxmark3 community

PlayGround

Contributor

Registered: 2019-05-08

Posts: 10

hello from hb

Hello,

i am paul, doing a hardware-workshop of the university in hb. im still in school (8th class) and doing my first steps with hardware.
in the lab is a proxmark easy (i believe), dont know the source exactly but believe chineese edition.

This device in generally works, i can read hf and lf cards with no problems.

Attached my device-informations:

./proxmark3 /dev/ttyACM0
Prox/RFID mark3 RFID instrument         
bootrom: master/v3.1.0-83-g1f61f19-suspect 2019-04-09 10:39:27
os: master/v3.1.0-83-g1f61f19-suspect 2019-04-09 10:39:28
fpga_lf.bit built for 2s30vq100 on 2015/03/06 at 07:38:04
fpga_hf.bit built for 2s30vq100 on 2019/03/20 at 08:08:07
SmartCard Slot: not available
         
uC: AT91SAM7S512 Rev B         
Embedded Processor: ARM7TDMI         
Nonvolatile Program Memory Size: 512K bytes. Used: 209316 bytes (40%). Free: 314972 bytes (60%).         
Second Nonvolatile Program Memory Size: None         
Internal SRAM Size: 64K bytes         
Architecture Identifier: AT91SAM7Sxx Series         
Nonvolatile Program Memory Type: Embedded Flash Memory         

i will learn about rfid technologies how to work with them. we have some sample cards here (need to find out what kind of) and some Readers, which do "something" when card is attached. (they simply blink or make some noise. some kind of blinky blinky lab stuff).

so i am pretty sure i will post a lot of questions here.

:-D

best regards
paul

iceman

Administrator

Registered: 2013-04-25

Posts: 9,538

Website

Re: hello from hb

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Your access rights has been updated.