Proxmark3 community

Roger_Ramjet

Contributor

From: Canada

Registered: 2020-02-20

Posts: 1

Thanks for the add

I just picked up a Proxmark3 3.0 so that I can further my read, write and clone ability with my implanted microchips.
I'm currently working on a wiring project for my 2015 Harley Davidson Street XG750 motorcycle that will allow me to be within 30 feet (10 meters) of my motorcycle and have it recognize me and come awake (turn on but not start). At present I have my motorcycle wired so that I can use my microchip in my left hand to start my motorcycle therefore bypassing the start button.
as the weather here in Canada is still a bit too cold to continue on my wiring project outside I hope to learn lots on how to clone the different tags for the different systems involved in my project.
so far I have installed an access controller from Dangerous Things which allows me to bypass the start button and start my motorcycle. I was in the process of installing a keyless ignition system from Digital Guard Dawg when winter arrived and I had to put my bike away for the season. and i just recently received a power sport security system from Viper that will be the last part to be installed in my system

iceman

Administrator

Registered: 2013-04-25

Posts: 9,538

Website

Re: Thanks for the add

Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.

Your access rights has been updated.