Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
When try to run the proxmark3
The antenna has no voltage as below
Is there any solution???
Thanks
>> Started prox, built Jul 13 2009 01:21:29
>> Connected to device
> tune
# LF antenna @ 0 mA / 0 mV [1273 ohms] 125Khz
# LF antenna @ 0 mA / 0 mV [1187 ohms] 134Khz
# HF antenna @ 0 mA / 0 mV [235 ohms] 13.56Mhz
Offline
Hi,
Give us more details about the setup:
- Have you attached antennas to the PM3?
- Where are they hooked up? To the test points, or to the USB connector?
- What is your antenna made of, and what does it looks like?
- Where have you bought your PM3?
- Can you show us pictures of the setup so we can understand what happened?
--
rleroy
Offline
Pages: 1