Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2015-10-04 12:01:24
- Glennd11
- Member
- Registered: 2015-10-04
- Posts: 2
New user - Driver problems
Hi all,
I have just received my pm3 and am struggling to flash it.
I am installing it on a windows 32 bit vista system, I have followed all the install procedures upto flashing the unit with the new bootrom - please see picture below
I next start the bootrom.bat file, hold down the button, plug the pm3 into the pc and wait for it to install. When it has installed i hit the return key and all i get is 'waiting for proxmark to appear on usb'
I would be most grateful if someone can steer me in the right direction on what i am doing wrong.
Thanks
Offline
#2 2015-10-04 12:50:26
- ntk
- Contributor
- Registered: 2015-05-24
- Posts: 701
Re: New user - Driver problems
Something is wrong. I don't see the part PORTS where the communication happens.
Perhaps you should cleanly repeat the step to install PM3 driver, then unplug/plug the PM3, then PORTS must recognise PM3
Last edited by ntk (2015-10-04 12:52:44)
Offline
#3 2015-10-04 18:09:55
- asper
- Contributor
- Registered: 2008-08-24
- Posts: 1,409
Re: New user - Driver problems
You have a libusb bootloader and you are trying to flash over it with the CDC-serial flasher; you need to use the old flasher.
Offline
#4 2015-10-04 18:16:06
- iceman
- Administrator
- Registered: 2013-04-25
- Posts: 9,537
- Website
Re: New user - Driver problems
which is inside the /client/hid-flasher/ folder..
Offline
#5 2015-10-05 18:03:58
- Glennd11
- Member
- Registered: 2015-10-04
- Posts: 2
Re: New user - Driver problems
Thanks iceman, i will give this a try
Offline