Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Everything was fine until now. Now i cant use any command, except help.
Even hw ver or hw tune is not working. It says "command not found".
The switch is on. The led STD is lit and CHR is flashing, all the letters (A, B, C, D) are off
Last edited by Elsin10 (2018-07-06 07:19:46)
Offline
Still no one knows the answer...
Offline
Damnn still no one knows !!! WTF
Nice forum... Marvelous
Offline
I even updated proxmark to the latest firmware and bootrom and still is not working.
I just figured out what i need to do to get what i need but the commands are not working
Any help ? Plz !!!
Offline
Are u using the proxmark client compiled together with the firmware and the bootrom? If not, plz use the client above; otherwise, check if u r running the client in sudo mode or you have correctly set the port number or even have correct drivers.
Offline
Are u using the proxmark client compiled together with the firmware and the bootrom? If not, plz use the client above; otherwise, check if u r running the client in sudo mode or you have correctly set the port number or even have correct drivers.
Everything is updated. Sudo mode? You mean that button?
How do i know if proxmark is in sudo mode?
[edit]
Which client ? The UI client ? No, im not using that one.
Thx for the reply
Last edited by Elsin10 (2018-07-06 06:45:49)
Offline
You mean this command ?
Upgrade the Proxmark bootrom by executing the following command:
sudo ./flasher -b ../bootrom/obj/bootrom.elfI haven't done that. It worked for the first time without doing that command
[Edit]
I'm on Windows, not on Linux
Last edited by Elsin10 (2018-07-06 06:42:16)
Offline
I was forgetting to type one simple line of command
./client/proxmark3.exe comXIt wasn't working because i was typing the commands in the MINGW32 and none of the commands works there, obviously !!!
So now everything is working fine!
It took some type but i figure it out!
Offline