Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
#1 2010-07-14 02:47:40
- wuninsu
- Member
- Registered: 2010-07-13
- Posts: 4
unable to stop target
I break the firmware. So, I want to recover it.
I connected 20-pin to the PM and I executed ArmPgm and click the Check.
But the message was unable to stop target.
I don't know why it is occured.
I connected the USB for power and 20-pin well
I think some part is wrong. I don't know how to check it. 
Offline
Pages: 1