Raw Commends on Mifare Cards

mopmopmop · 2019-03-18 14:49:58

I'm a student trying to learn RFID system with the help PM3.
I came into a problem that when I used the RAW Commands, the response was never correct as its tips in the Proxmark Tool.
I don't know it's the CRC or other problems.

Is there any instruction or document about the usage of raw commends ?
Much appreciate if anyone can tell me.
Thx

iceman · 2019-03-18 19:53:25

read a datasheet over iso14443a commands?

mopmopmop · 2019-03-19 15:43:39

I read the iso14443a.
Commands like WUPA and Anti-collision could work, but commands like read and write that need extra datas fails.

Does RAW commands means the PM3 sends whatever I write or it will automatically append the CRC or other thing to the commands that were eventually broadcasted?

iceman · 2019-03-19 16:59:46

did you look at the help text for the raw command?

mopmopmop · 2019-03-21 02:39:45

proxmark3> hf 14a raw -c -p -s 3000
received 7 octets
04 41 16 12 C5 48 85
received 18 octets
04 41 16 DB 12 C5 48 85 1A 48 00 00 00 00 00 00 AE 1F

This is the response when I used RAW commands 3000 to read a Mifare Ultralight card.
The help text said the correct answer is 16 bytes but it was actually 18 bytes.
It confuses me.

iceman · 2019-03-21 06:55:59

its correct, you just have two crc bytes in the end that you missed when you read the datasheet

Proxmark3 community

Announcement

#1 2019-03-18 14:49:58

Raw Commends on Mifare Cards

#2 2019-03-18 19:53:25

Re: Raw Commends on Mifare Cards

#3 2019-03-19 15:43:39

Re: Raw Commends on Mifare Cards

#4 2019-03-19 16:59:46

Re: Raw Commends on Mifare Cards

#5 2019-03-21 02:39:45

Re: Raw Commends on Mifare Cards

#6 2019-03-21 06:55:59

Re: Raw Commends on Mifare Cards

Board footer