Proxmark3 community
Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
You are not logged in.
Announcement
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
#1 2018-09-28 21:14:30
- Spyder
- Contributor
- Registered: 2017-12-20
- Posts: 21
[SOLVED] How to connect alternative LF Antenna to PM3 Easy
Hi
How does the LF Antenna on the PM3 Easy connect to the main circuit board?
I can't see any obvious connectors.
Have looked and cannot find any references.
Thanks in advance
Spyder
Last edited by Spyder (2018-10-02 18:17:43)
Offline
#2 2018-10-02 18:17:25
- Spyder
- Contributor
- Registered: 2017-12-20
- Posts: 21
Re: [SOLVED] How to connect alternative LF Antenna to PM3 Easy
£2.95 from eBay https://www.ebay.co.uk/itm/RFID-Reader- … 2749.l2649
Works perfectly.
Last edited by Spyder (2018-10-02 18:23:18)
Offline
#3 2019-02-28 13:26:35
- tristanik
- Contributor
- Registered: 2014-11-25
- Posts: 96
Re: [SOLVED] How to connect alternative LF Antenna to PM3 Easy
But in this way the two antennas work in parallel
Offline
#4 2019-07-18 11:49:27
- w106
- Contributor
- Registered: 2019-07-18
- Posts: 6
Re: [SOLVED] How to connect alternative LF Antenna to PM3 Easy
You can connect the new antenna as Spyder said then put it close to the original antenna as the picture，if you put the new antenna away from the original one, you will get a much lower voltage of the LF antenna.
Otherwise, you can remove the origenal antenna and just connect the new one to the central screws (with some arrows near it)
Sorry for my bad English
Offline