Proxmark3 community

tunix

Contributor

Registered: 2021-11-16

Posts: 5

lot

hello
i am tobi, i bought the proxmark 3 easy mainly for reading the
rfid from the lto 1, 2, 3 tapes because of a verry good post in
this forum about reading lto tapes. so i thought it will work for
me too.  i installed the newest firmware but i dont get any information.
the hf antenna seems to connect because watching the
antenna shows the voltage going different if a tape is in the near.
it is possible that it cant work for the 1, 2, 3 tapes, because
the post is about lto 5 tapes? i tryed the lto funktion and the
hf 14a directly too without any result.
so an other idea is why it doesnt work is, that maybe the
frequency may out of the tolerance from the lto rfid
or the power of the antenna could be to low?
i am no professional in electronics or programming
but i searched a lot for this problem but without a
solution.
regards

ps. i installed it on kali linux without graphical interface
   (gui dont want to run on the older hp pc)

iceman

Administrator

Registered: 2013-04-25

Posts: 9,538

Website

Re: lot

Welcome and thank you for reading the introduction post http://www.proxmark.org/forum/viewtopic.php?id=1125.

Your access rights has been updated.